beautypg.com

Figure 1-4: remove the ramp bracket from the crate, Figure 1-5: hardware box contents – Dynojet 200: Installation Guide User Manual

Page 14

background image

Motorcycle Dynamometer Installation Guide

C H A P T E R 1
Uncrate the Dyno

1-6

5

Remove the ramp bracket. The ramp bracket is attached to the bottom of the
crate.

Figure 1-4: Remove the Ramp Bracket from the Crate

6

Remove the hardware box containing two outrigger bolts and lock washers, the
tire carriage screw handle, and the screw support bracket. Refer to Figure 1-5.
If you ordered a ramp, the hardware box will also contain six carriage bolts, six
flat washers, six lock washers, and six nuts to be used in the ramp installation.
Refer to “Ramp Assembly” on page 1-14 for ramp assembly instructions,

Figure 1-5: Hardware Box Contents

See also other documents in the category Dynojet Equipment: