In-system mode, Connecting the power supply, Figure 6: standalone board connections – Achronix Speedster22i HD1000 Development Kit User Guide User Manual
Page 19: Standalone board connections
UG034, July 1, 2014
19
Standalone Board Connections
USB Cable
JTAG Ribbon Cable
Development PC (Client)
Bitporter Pod
Power Supply
Development Board
Figure 6: Standalone Board Connections
In-system Mode
You need to plug the development board into an available PCIe x8 slot of the development
PC. You need to leave the adjacent slot vacant to accommodate the clearance requirements
for the component side of the board. Figure 7 shows the connections for this mode.
Connecting the Power Supply
Although the individual components on the board use different voltage levels, each of these
is generated on the board using a single 12V power supply input. You may use a spare 12V
supply connector from the development PC power supply.