Achronix Speedster22i HD1000 Development Kit User Guide - Manual (Page 15)

UG034, July 1, 2014 15
PCIe Plug In Card
Power Supply
Figure 4: In-System Use Mode
On-Board Memory
The development board has the following memories available for system design.

A 204-pin SO-DIMM DDR3 module with 2.133 Gb/s performance.

To use as the primary off-chip memory for all applications. This supplements the
on-chip BRAM.

To serve as a demonstration of the embedded DDR3 controller capability.

A DDR3 device (2 Gb @ 1066 MHz) soldered on the board which you can use at 2.133
Gb/s performance.

Two RLDRAM3 (each 16 Mb x 36 for a total of 576 Mb @ 1066 MHz)

A QDR2+ device (2 Mb x 36 = 72 Mb @ 633 MHz) which you can use for high-
bandwidth, low-latency, random-access requirements such as classification and policy
lookup in networking applications.

An SPI Flash device which you can use to store configuration bitstreams on board.
On-Board Controller
The development board comes equipped with an on‐board, Atmel ATmega2560 AVR
microcontroller. You can use this microcontroller to perform the following tasks:

Control power sequencing of the board and any connected peripherals.

Measure the temperature captured via the on‐chip temp diode of the HD1000 FPGA.

Monitor power consumption of some of the key functional blocks.

SerDes