Roadi RDT51 - Manual (Page 95)

OWNER S MANUAL
,
OBD2 Car Scanner
91
CHECK
Scan tool doesn’t power up
If the scan tool won’t power up or operates incorrectly in any other way,
you need to do the following to check up:
Check if the scan tool’s OBD II connector is securely connected to the
vehicle’s DLC;
Check if the DLC pins are bent or broken. Clean the DLC pins if
necessary.
Check vehicle battery to make sure it is still good with at least 8.0
volts.If uses internal batter power.
Verify that the ignition is ON;
Check if the scan tool’s OBD II connector is securely connected to the
vehicle’s DLC;
Verify that the vehicle is OBD2 compliant;
Turn the ignition off and wait for about 10 seconds. Turn the ignition
back to on and continue the testing.
Verify the control module is not defective
Operating Error
If the scan tool freezes, then an exception occurs or the vehicle’s ECU
(Engine Control Unit) is too slow to respond to requests. You need to do
the following to reset the tool:
Press and hold POWER button for at least 2 seconds to reset the scan
tool.
Turn the ignition off and wait for about 10 seconds. Turn the ignition back
to on and continue the testing.
10. Review Data
The Review Data function allows viewing of data from last test recorded
by the scan tool.