Roadi RDT51 - Manual (Page 51)

OWNER S MANUAL
,
OBD2 Car Scanner
47
CHECK
Diagnostic
=============================
System Status
=============================
If the "LINKING ERROR" message does not go away, then there
mig ht be problems for the scan tool to communicate with the vehicle.
Contact your local distributor or the manufacturer's customer service
department for assistance.
7. You will be prompted to erase previously stored data.
Review previously stored data thoroug hly before erasing.
Erase previously
stored data to save
data from this test?
YES NO
If no data is stored in the scan tool, above prompt will not show up.
8. If you wish to erase the data, press
ENTER button; if you do not want
to erase the data, press
ESC or use LEFT/RIGHT button to select NO
and press
ENTER to continue.
9. View a summary of system status (MIL status, DTC counts, Monitor
status) on screen. Wait a few seconds or press any key for Diagnostic
Menu to come up.
MIL Status ON
Codes Found
6
Monitors N/A 3
Monitors OK 3
Monitors INC 5
If more than one module is detected, you will be prompted to select a
module before testing.