Dell POWEREDGE C6105 - Manual (Page 71)

Using the System Setup Program | 71
Token Setup option Description
Configuration network interface to Dedicated-Nic.
480F BMC LAN Port
Configuration Specifies the current mode of operation for the BMC
network interface to Shared-Nic.
4810 DHCP Enabled Disable to get BMC IP address through DHCP server.
4811 DHCP Enabled Enable to get BMC IP address through DHCP server.
4816 Force PXE Boot
only Enable PXE to be the Only boot.
4817 Force PXE Boot
only Disable PXE to be the Only boot.
4838 Flow Control Remote access flow control by none.
4839 Flow Control Remote access flow control by hardware.
483A Flow Control Remote access flow control by Software.
4840 Force USB first Disable USB to be the first boot device.
4841 Force USB first Enable USB to be the first boot device, the priority is
higher than PXE. It takes effect on next boot.
4842 iSCSI Remote Boot
4843 iSCSI Remote Boot Config Onboard Lan to iSCSI.
4850 GART Error Report Disable GART Error report. This option should
remain disabled for the normal operation. The driver
developer may enable it for testing purpose.
4851 GART Error Report Enable GART Error report. This option should
remain disabled for the normal operation. The driver
developer may enable it for testing purpose.
4854 Secure Virtual
Machine Mode Disable Secure Virtual Machine Mode.
4855 Secure Virtual
Machine Mode Enable Secure Virtual Machine Mode.
4858 ACPI SRAT Table Disable the building of ACPI SRAT Table. When this
option is Disabled, NUMA is not supported.
4859 ACPI SRAT Table Enable the building of ACPI SRAT Table. When this
option is Enabled, NUMA is supported.