beautypg.com

Cable routing for lsi 9265-8i card – Dell POWEREDGE C6105 User Manual

Page 115

background image

Installing System Components | 115


7 Holding the card by its edges, position the card so that the card-edge

connector aligns with the expansion-card connector. See Figure 3-17.

8 Insert the card-edge connector firmly into the expansion-card

connector until the card is fully seated.

9 Replace the screw securing the LSI 9265-8i card.
10 Place the LSI 9265-8i card assembly into the system-board assembly.

See Figure 3-16.

11 Replace the four screws that secure the LSI 9265-8i card assembly.

Make sure the cable is routed properly as shown in Figure 3-18.

12 Install the system-board assembly. See "Installing a System-Board

Assembly" on page 93.

Cable Routing for LSI 9265-8i Card

1 Connect the mini-SAS&SGPIO cable to the LSI 9265-8i card, and

connect the other end of the cable to the corresponding connectors on
the interposer extender. Make sure the cables should go through the
cable clip ring. See Figure 3-18.

2 Connect the RAID battery cable to the BBU interposer card on the LSI

9265-8i card, and connect the other end of the cable to the
corresponding connector on the RAID battery.

NOTE: When connecting the RAID battery cable, the BBU interposer card
should be installed on the LSI 9265-8i card. The BBU interposer card in the
figure below is just for you reference.