Dell POWEREDGE C6105 - Manual (Page 28)

28 | About Your System
Error Code Error Message Response Error Cause Recovery
Method
4106 SPD missing byte 23 or 25 Pause DIMM bad Change DIMM
4107 Bank interleave requested
but not enabled Warning DIMM bad Change DIMM
4108 Dram ECC requested but
not enabled Pause DIMM bad Change DIMM
4109 Online spare requested but
not enabled Pause DIMM bad Change DIMM
410A DIMM(s) Running in
Minimum Mode Pause DIMM bad Change DIMM
410B No DQS Receiver Enable
pass window found Pause DIMM bad Change DIMM
410C DQS Rcvr En pass window
CHA to CHB too large Pause DIMM bad Change DIMM
410D DQS Rcvr En pass window
too small (far right of
dynamic range) Pause DIMM bad Change DIMM
4160 The processor(s) installed
in your system are not
multiprocessing capable. halt Unknown CPU Install correct
CPU
5120 CMOS cleared by jumper Pause CMOS clear by
jumper No action
5121 Password cleared by jumper Pause Password clear by
jumper No action
8101 Warning! USB Host
Controller not found at the
specified address!!! Warning USB Host
controller bad.
No action
8102 Error! USB device failed to
initialize!!! Warning USB init fail. Check the USB
device
connected.
8103 Warning! Unsupported
UBS device found and Warning Detected an
unsupported USB
Check the USB
device