Dell POWEREDGE C6105 - Manual (Page 145)

Installing System Components | 145
Cooling Fans
Removing a Cooling Fan
WARNING: Do not attempt to operate the system without the cooling fans.
WARNING: The cooling fan can continue to spin for some time after the system
has been powered down. Allow time for the fan to stop spinning before removing
it from the system.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Recommend to turn off the system, including any attached peripherals,
and disconnect the system from its electrical outlet.
2 Open the system. See "Opening the System" on page 142.
3 Disconnect the fan‘s power cable from the fan-controller board.
Note the routing of the cable through the tabs on the chassis as you
remove them from the system. You must route these cables properly
when you replace them to prevent the cables from being pinched or
crimped.
4 To remove the cooling fan 2, 3 or 4, just directly lift it out of the
cooling-fan cage. See Figure 3-36.