Dell POWEREDGE C6105 - Manual (Page 67)

Using the System Setup Program | 67
 To check token active status:
./syscfg --istokenactive=D4_token_id
(Example: ./syscfg --istokenactive=0x002D to check the token
active status of NIC1)
 To change the SETUP option thru BMC memory directly:
./ipmitool raw
(Example: ./ipmitool raw 0xc 1 1 3 10 106 42 120 to set IP address
of BMC LAN port as 10.106.42.120)
The D4 token table
Token Setup option
Description
002D NIC1 - 82576 Enable the system‘s primary embedded network
interface controller (full-function), including its PXE
boot-ROM.
002E NIC1 - 82576 Disable the system‘s primary embedded network
interface controller.
006E NIC1 - 82576 Enable the system‘s primary embedded network
interface controller, but don‘t enable the NIC‘s
associated PXE or RPL boot-ROM.
0051 1st Boot Device Set the diskette device to be inserted as the first
device in the boot sequence.
0052 1st Boot Device Only the hard drive can be in the boot sequence
0053 1st Boot Device Boot seq device list.
0054 1st Boot Device Set the CDROM to be inserted as the first device in
the boot sequence.
0087 Video Enumeration The onboard video controller is used for boot-time
messages.
0088 Video Enumeration The first add-in video controller is used for boot-time
messages. Depending on the BIOS search order and
system slot layout.
00A1 Restore on AC
Power Loss After an AC power loss, when AC power is restored,
the system stays off.