Dell POWEREDGE C6105 - Manual (Page 140)

140 | Installing System Components
2 Locate the battery location. See ―System Board Connectors‖ on page
198.
CAUTION: To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
3 Gently pull the retention clip over the battery towards the positive side
of the connector and lift the battery out of the connector. See Figure 3-
33.
4 Hold the new battery with the ―+‖ facing the retention clip on the
battery connector. See Figure 3-33.
5 Gently pull the retention clip towards the positive side of the
connector and slide the battery into the connector until the retention
clip snaps into place. See Figure 3-33.
6 Replace the system-board assembly. See ―Installing a System-Board
Assembly‖ on page 93.
7 Enter the System Setup program to confirm that the battery is
operating properly. See ―Using the System Setup Program‖ on page 37.
8 Enter the correct time and date in the System Setup program‘s Time
and Date fields.
9 Exit the System Setup program.