Dell POWEREDGE M1000E - Manual (Page 294)

278 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
dot1x timeout supp-timeout
17
dot1x timeout supp-timeout
Sets the time in seconds that a switch waits for a response to an Extensible Authentication Protocol
(EAP) request frame from the client before resending the request.
Synopsis dot1x timeout supp-timeout seconds
Operands seconds Specifies the number of seconds that the switch waits for a response to the
EAP frame. The range of valid values is 1-65535.
Defaults The default timeout is 30 seconds.
Command
Modes
Interface configuration mode
Description Use this command to specify the EAP response timeout.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To set 45 seconds as the switch-to-client retransmission time for the EAP request frame:
switch(config)#interface extengigabitethernet 0/16
switch(conf-if-te-0/16)#dot1x timeout supp-timeout 40
See Also none