Dell POWEREDGE M1000E - Manual (Page 168)

152 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
seq (extended MAC ACLs)
10
seq (extended MAC ACLs)
Inserts a rule anywhere in the MAC ACL.
Synopsis seq value {deny | permit} {any | host MAC _ACL| MAC_ACL} {any | host MAC _ACL| MAC _ACL}
[EtherType |arp |fcoe | ipv4] [count]
no seq value
Operands value Specifies the sequence number for the rule. The range of valid values is
0-65535.
permit or deny Specifies rules to permit or deny traffic.
any Specifies any source MAC address.
host MAC_ACL Specifies the source host MAC address for which to set permit or deny
conditions. Use the format HHHH.HHHH.HHHH.
MAC_ACL Specifies the source host MAC address for which to set permit or deny
conditions. Use the format HHHH.HHHH.HHHH.
any Specifies any destination MAC address.
host MAC_ACL Specifies the destination host address for which to set permit or deny
conditions. Use the format HHHH.HHHH.HHHH.
MAC_ACL Specifies the destination host address for which to set permit or deny
conditions. Use the format HHHH.HHHH.HHHH.
Ethertype Specifies the protocol number for which to set the permit or deny conditions.
The range of valid values is 1536-65535.
arp Specifies to permit or deny the Address Resolution Protocol (0x0806).
fcoe Specifies to permit or deny the Fibre Channel over Ethernet Protocol
(0x8906).
ipv4 Specifies to permit or deny the IPv4 protocol (0x0800).
count Enables the counting of the packets matching the rule.
Defaults By default, no MAC ACLs are configured.
Command
Modes
Feature Access Control List Configuration mode
Description Use this command to insert a rule anywhere in the MAC ACL; it configures rules to match and
permits or drops traffic based on the source and destination MAC addresses, and the protocol type.
You can also enable counters for a specific rule. There are 255 ACL counters supported per port
group. Use the no seq value command to remove a rule from the MAC ACL.
Usage
Guidelines
The first set of {any | host MAC_ACL | MAC_ACL} parameters is specific to the source MAC
address. The second set of {any | host MAC_ACL | MAC_ACL} parameters is specific to the
destination MAC address.