Switchport mode – Dell POWEREDGE M1000E User Manual
Page 70

54
Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
switchport mode
3
switchport mode
Sets the mode of the Layer 2 interface.
Synopsis
switchport mode {access | trunk | converged}
Operands
access
Sets the Layer 2 interface as access.
trunk
Sets the Layer 2 interface as trunk.
converged
Sets the layer 2 interface as converged.
Defaults
There are no defaults for this command.
Command
Modes
Interface configuration mode
Description
Use this command to set the mode of the Layer 2 interface.
Usage
Guidelines
With this command, the interface can be set to access mode for non-FCoE traffic, or converged
mode for FCoE/non-FCoE traffic. However, the preferred way of configuring an interface for FCoE is
with the command fcoeport with the port configured in access mode.
Examples
To set the mode of the interface to access:
switch(conf-if-te-0/19)#switchport mode access
To set the mode of the interface to trunk:
switch(conf-if-te-0/19)#switchport mode trunk
To set the mode of the interface to converged:
switch(conf-if-te-0/19)#switchport mode converged
See Also
show vlan brief, show interface switchport, switchport trunk