Dell POWEREDGE M1000E - Manual (Page 154)

138 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
fcoeport
9
fcoeport
Applies the FCoE map to an interface.
Synopsis fcoeport
Operands none
Description Use this command to apply the FCoE map to an interface. You must be in interface mode for a
selected interface.
Defaults There are no default configurations for this command.
Command
Modes
Interface configuration mode
User Guidelines If the interface is configured as fcoeport, the fcoeport configuration will take precedence over the
switchport mode. If the switchport mode is configured as access or trunk it will be ignored.
Example Enter interface mode, then apply the FCoE map.
switch(config)#interface extengigabitethernet 0/20
switch(conf-if-ext-0/20)#fcoeport
See Also fcoe-map