Dot1x timeout tx-period – Dell POWEREDGE M1000E User Manual

Page 295

Dell Converged Enhanced Ethernet Command Reference

279

53-1002115-01

dot1x timeout tx-period

Sets the number of seconds that the switch waits for a response to an Extensible Authentication
Protocol (EAP) request or identity frame from the client before retransmitting the request.

Synopsis

dot1x timeout tx-period seconds

Operands

seconds

Specifies the time in seconds between successive request ID attempts. The
range of valid values is 1-65535.

Defaults

The default timeout is 30 seconds.

Command

Modes

Interface configuration mode

Description

Use this command to set the interval between successive attempts to request an ID (EAP ID Req).

Usage

Guidelines

There are no usage guidelines for this command.

Examples

To set 34 as the number of seconds to wait for a response to an EAP-request or identity frame from
the client before retransmitting the request:

switch(config)#interface extengigabitethernet 0/16

switch(conf-if-te-0/16)#dot1x timeout tx-period 34