Dell POWEREDGE M1000E - Manual (Page 237)

Dell Converged Enhanced Ethernet Command Reference 221
53-1002115-01
sflow polling-interval (interface version)
13
sflow polling-interval (interface version)
Configures the polling interval at the interface level.
Synopsis sflow polling interval interval value
no sflow polling interval
Operands interval value Specifies a value in seconds to set the polling interval. The range of valid
values is 1-65535.
Defaults The default counter polling interval value is 20 seconds.
Command
Modes
Interface Mode
Description Use this command to configure the polling interval for an interface. The interval is the maximum
number of seconds between successive samples of counters to be sent to the collector.
Use the no sflow polling interval interval command to return to the default value.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To set the polling interval to 135 seconds:
switch(conf-if-te-0/1)#sFlow polling interval 135
See Also sflow polling interval (global version)