Permit (standard acls) – Dell POWEREDGE M1000E User Manual

Page 166

150

Dell Converged Enhanced Ethernet Command Reference

53-1002115-01

permit (standard ACLs)

Configures a MAC address rule to permit traffic based on the source MAC address.

Synopsis

permit {MAC_ACL | any} [count]

no permit {MAC_ACL | any}

Operands

MAC_ACL

Specifies the source host MAC address for which to set permit conditions.
Use the format HHHH.HHHH.HHHH.

any

Specifies any source MAC address.

count

Enables the counting of the packets matching the rule.

Defaults

By default, no MAC ACLs are configured.

Command

Modes

Feature Access Control List Configuration mode

Description

Use this command to configure rules to match and to permit traffic based on the source MAC
address. You can also enable counters for a specific rule. There are 255 ACL counters supported
per port group. Use the no permit command to remove a rule from the MAC ACL.

Usage

Guidelines

There are no usage guidelines for this command.

Example

To create a rule in a MAC standard ACL to permit traffic from the source MAC address

0022.3333.4444

and to enable the counting of packets:

switch(conf-macl-std)#permit 0022.3333.4444 count

To delete a rule from a MAC standard ACL:

switch(conf-macl-std)#no permit 0022.3333.4444