Lacp system-priority – Dell POWEREDGE M1000E User Manual

Page 143

Dell Converged Enhanced Ethernet Command Reference

127

53-1002115-01

lacp system-priority

Sets the Link Aggregation Control Protocol (LACP) system priority.

Synopsis

lacp system-priority value

no lacp system-priority

Operands

value

Specifies the value of the LACP system priority. The range of valid values is
1-65535.

Defaults

The default system-priority value is 32768.

Command

Modes

Global configuration mode

Description

Use this command to set the system priority of a local system. This determines which system is
responsible for resolving conflicts in the choice of aggregation groups. Use the no lacp
system-priority command to reset the system priority to the default value.

Note

Lower numerical values have higher priorities.

Usage

Guidelines

There are no usage guidelines for this command.

Examples

To set the LACP system-priority to 68:

switch(config)#lacp system-priority 68

To clear the configured LACP system-priority:

switch(config)#no lacp system-priority