Dell POWEREDGE M1000E - Manual (Page 149)

Dell Converged Enhanced Ethernet Command Reference 133
53-1002115-01
Chapter
8
Layer 2 System Commands
mac-address-table
Use this command to set the aging time or to add static addresses to the MAC address table.
Synopsis mac-address-table {aging-time seconds| static mac-addr forward [port-channel number | {in |
ex}tengigabitethernet slot/port | vlan vlan_id]}
no mac-address-table {aging-time | static mac-addr forward [port-channel number | {in |
ex}tengigabitethernet slot/port | vlan vlan_id]}
Operands aging-time seconds
Specifies the time in seconds that a learned MAC address will persist after
the last update. If the aging time is set to zero (0), it means that aging is
disabled. The range of valid values is 10-100000.
static mac-addr Specifies the Media Access Control (MAC) address (unicast or multicast) to
add to the address table. Packets with this destination address received in
the specified VLAN are forwarded to the specified interface.
forward Forwards the MAC address to the interface.
port-channel number
Specifies the port-channel number. The range of valid values is 1 to 63.
extengigabitethernet
Specifies a valid external 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
intengigabitethernet
Specifies a valid internal 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
vlan vlan_id Specifies the VLAN number. The range of valid values is 1-3583.
Defaults The default aging time is 300 seconds.
Command
Modes
Global configuration mode
Description Use this command to set the aging time or to add static addresses to the MAC address table.
Usage
Guidelines
The vlan keyword is mandatory because the switch only supports independent VLAN learning (IVL).