Dell POWEREDGE M1000E - Manual (Page 13)

Dell Converged Enhanced Ethernet Command Reference xiii
53-1002115-01
About This Document
In this chapter
• How this document is organized . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xiii
• Supported hardware and software. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xiv
• Document conventions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xiv
• Notice to the reader . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xv
• Getting technical help . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xvi
How this document is organized
This document is organized to help you find the information that you want as quickly and easily as
possible.
The document contains the following components:
• Chapter 1, “CLI Basics” describes how to access the switch and the CEE CLI command modes.
• Chapter 2, “Configuration Management Commands” describes the commands to manage the
configuration files and includes other file management commands.
• Chapter 3, “VLAN Commands” describes the commands to create and manage Virtual LAN
interfaces.
• Chapter 4, “Interface Commands” describes the commands to configure interfaces.
• Chapter 5, “IP Configuration Commands” describes the commands for configuring IP.
• Chapter 6, “Link Layer Discovery Protocol Commands” describes the commands that support
the Link Layer Discovery Protocol (LLDP) implementation.
• Chapter 7, “Link Aggregation Control Protocol Commands” describes the commands to clear
counters of all LACP aggregators or a given LACP aggregator.
• Chapter 8, “Layer 2 System Commands” describes the commands to configure Layer 2
features.
• Chapter 9, “FCoE Configuration Commands” describes the commands for configuring and
maintaining FCoE.
• Chapter 10, “Layer 2 ACL commands” describes the commands to configure, manage, and
view MAC addresses.
• Chapter 11, “Spanning Tree Protocol Commands” describes the commands to configure the
Spanning Tree Protocol (STP), Rapid Spanning Tree Protocol (RSTP), and Multiple Spanning
Tree Protocol (MSTP).
• Chapter 12, “Internet Group Management Protocol Commands” describes the commands
used to configure and maintain IGMP snooping.