Dell POWEREDGE M1000E - Manual (Page 278)

262 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
show qos maps
16
show qos maps
Displays information on the defined QoS maps.
Synopsis show qos maps [{cos-mutation [name] | cos-traffic-class [name]}]
Operands cos-mutation name
Specifies to report on only the named CoS-to-CoS mutation QoS map.
cos-traffic-class name
Specifies to report on only the named CoS-to-Traffic Class QoS maps.
Defaults The default behavior without any specified operands is to report on all defined QoS maps.
Command
Modes
EXEC mode
Description Use this command to display information on the QoS defined maps. For each QoS map, the
configuration state is displayed with a list of all interfaces bound to the QoS map.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To display information on the defined QoS maps:
switch#show qos maps
CoS-to-CoS Mutation map 'test'
In-CoS: 0 1 2 3 4 5 6 7
--------------------------------
Out-CoS: 0 1 2 3 5 4 6 7
Enabled on the following interfaces:
Te 0/5
CoS-to-Traffic Class map 'test'
Out-CoS: 0 1 2 3 4 5 6 7
-------------------------------------
TrafficClass: 0 1 2 3 5 4 6 7
Enabled on the following interfaces:
Te 0/5
See Also qos maps, show qos interface