Dell OptiPlex GX110 - Manual (Page 67)

Figure 15. Removing the Expansion-Card Cage From the Mini Tower Chassis
4. Slide the expansion-card cage out of the chassis.
5. Lift the expansion-card cage up and away from the chassis.
To replace the expansion-card cage in the mini tower chassis, perform the following steps:
1. With the securing lever in the upright position, align the slots in the left side of the expansion-card cage with the tabs on the back and bottom
of the chassis (see Figure 15 ). Slide the expansion-card cage into place.
2. Rotate the securing lever inward until it is flush with the top side of the chassis. Make sure that the riser board is fully seated in the riser board
connector on the system board (see Figure 9 ).
3. Reconnect any cables you removed in step 2 of the previous procedure.
Back to Contents Page
1 Securing lever
2 Tabs (2)
3 Slots (2)