Dell OptiPlex GX110 - Manual (Page 105)

7. To reset the chassis intrusion detector, enter the System Setup program and reset Chassis Intrusion to Not Detected.
See the User's Guide for detailed information on the chassis intrusion detector.
DIMMs
Figure 25. DIMM Removal
To remove a DIMM, perform the following steps:
1. Push outward on the two DIMM socket ejectors simultaneously until the DIMM is released from its socket.
2. Lift the DIMM away from the socket.
To install a DIMM, press the DIMM fully into the socket while closing the ejectors to lock the DIMM into the socket (see Figure 26).
Figure 26. DIMM Installation
Microprocessor/Heat Sink Assembly
Figure 27. Microprocessor/Heat Sink Assembly Removal
ALERT! Cover was previously removed.
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the
chassis intrusion detector.
1 Ejectors (2)
CAUTION: Use a wrist grounding strap as explained in " Precautionary Measures ."
1 Ejectors (2)
2 Notches (2)