Dell OptiPlex GX110 User Manual
Page 38
Save the screw for use when you install the expansion card later in this procedure.
Figure 9. Removing the Filler Bracket
3. Insert the expansion card into the expansion-card connector.
a. If the expansion card is full-length, insert the front end of the card into the corresponding card guide on the inside front of the
chassis as you insert the card into its connector.
b. Insert the card's edge connector firmly into the expansion-card connector.
c. Gently rock the card into the connector until it is fully seated (see
for instructions for
the small-form-factor, low-profile, midsize, and mini tower chassis, respectively).
Figure 10. Installing an Expansion Card in a Small-Form-Factor Chassis
Figure 11. Installing an Expansion Card in a Low-Profile Chassis
Figure 12. Installing an Expansion Card in a Midsize Chassis
1 Expansion card
2 Card-edge connector
3 Riser board
4 Expansion-card connector
5 Expansion-card cage
1 Expansion card
2 Card-edge connector
3 Riser board
4 Expansion-card connector
5 Expansion-card cage