Dell OptiPlex GX110 User Manual
Page 26
d. To further ensure proper positioning of the drive in the bracket, insert and tighten all four screws in the order in which the holes
are numbered (the holes are labeled "1" through "4").
6. Slide the drive into the drive bay until the drive snaps securely into place (see
Make sure that both bracket tabs snap into place in the drive bay.
Figure 11. Inserting the New Drive Into the Drive Bay
7. Connect a DC power cable to the power input connector on the back of the drive (see
).
8. Connect the appropriate interface cable to the interface connector on the back of the drive (see
).
If your system came with an EIDE CD-ROM or tape drive, use the spare connector on the existing interface cable. Otherwise, use the EIDE
interface cable provided in the drive kit.
NOTICE: You must match the colored strip on the cable with pin 1 on the drive's interface connector to avoid possible damage
to your system.
Figure 12. Attaching Diskette Drive or Tape Drive Cables
1 5.25-inch drive
2 Bracket tabs (2)
3 Bracket
1 5.25-inch drive
1 DC power cable
2 Power input connector
3 Interface connector
4 Diskette/tape drive interface cable