Changing the seed box or hopper – Great Plains YP3025 Operator Manual User Manual
Page 43

Great Plains Manufacturing, Inc.
Operating Instructions
39
2013-09-09
401-703M
Changing the Seed Box or Hopper
Note: The YP3010HDP/20P/25 planter accepts the
Great Plains 82bu hopper,150bu
a
hopper, or bulk
seed boxes that meet the Pioneer
b
ProBox® spec-
ification.
Tipping Hazard:
Place or remove a hopper only when empty. A full hopper can
weigh between 5,000 and 10,000 lbs (2700-4500 kg), which is
above the lifting and balance capability of most tractors and
farm forklifts.
1.
Move the planter to an area of level ground and suffi-
cient room to maneuver a tractor or fork-loader.
2.
Unhitch tank cart if present.
Refer to Figure 38 (depicting identical operation on YP40)
3.
Disconnect hopper level sensor (if installed).
4.
Remove the pin
securing the left end of the walk-
board to the ladder assembly.
5.
Swing the walkboard open, and secure it at full open
with the keeper
.
6.
Raise the planter. This causes the rear transport
wheels to move forward, providing closer access for
the lifter.
7.
Back up the planter about three feet (1m). This
causes the rear transport wheels to caster forward,
further reducing the reach required for lifting.
8.
Turn off the seed box fan.
9.
Put the towing tractor in Park. Shut off engine.
Remove key.
10. Close the slide gate at the base of the hopper or
seed box.
Refer to Figure 39
11. Remove the two pins
, at opposite corners, used to
retain the seed box or hopper. Remove these pins
even if no container is presently mounted.
Refer to Figure 40 (depicting identical operation on YP24)
12. Align the lifting forks with the slots in the rear of the
seed box or hopper. Slowly drive forward until the
forks are completely under the container.
13. Slowly lift the seed container above the bracket, and
back away from the planter.
14. Lower the container to the ground for exchange with
the next seed container.
a. The 150bu hopper is incompatible with on-board fertilizer tanks.
b. PROBOX® is a registered trademark of Pioneer Hi-Bred International, Inc.
1
2
Figure 38
Walkboard Pin and Keeper
29312
3
3
Figure 39
Seed Box Lock Pins
29267
1
2
.eps
100%
Figure 40
Removing/Mounting Hopper
26121
3