Great Plains YP3025 Operator Manual - Manual (Page 21)

Great Plains Manufacturing, Inc. Table of Contents Index Preparation and Setup 17
2013-09-09 Table of Contents Index 401-703M
Electrical Hookup
Refer to Figure 5
Make sure tractor is shut down with accessory power off
before making connections.
1. Mate lighting connector to tractor outlet.
2. Mate monitor connector to tractor harness.
3. Mate any optional or aftermarket electrical connec-
tors.
Make connections prior to planter movement. Some
planter hydraulic circuits are under monitor control.
Hitching with 3-Point
Refer to Figure 6
1.
If the planter is model YP3025-2415 (“Even Row
15in”), check the configuration of the hitch offset at
“YP3010HDP-2415 3-Point Hitch” on page 169.
2. Connect your tractor 3-point to the planter 3-point
hitch. If using quick hitch be sure planter locks into
hitch securely.
3. Raise tractor 3-point enough to relieve pressure from
parking stands.
Load Sway Risk:
Adjust 3-point hitch arms and sway blocks to minimize any
side-to-side sway to assure proper tracking in the field and
safe road travel.
4. Connect hydraulic hoses to tractor remotes. See
“Hydraulic Hookup” on page 15.
5. Connect electrical cables. See “Electrical Hookup”
on page 17.
6. Swing up and pin up 3-point stands. See “Storing
3-Point Parking Stands” on page 19.
7. Remove and store main tongue parking stand. See
“Store Main Parking Stand” on page 19.
Figure 5
Connector Identification
25236
25237
1
2
Figure 6
3-Point Hitching
21924