Great Plains YP3025 Operator Manual - Manual (Page 28)

401-703M Table of Contents Index 2013-09-09
24 YP3010HDP/3020P/3025 Table of Contents Index Great Plains Manufacturing, Inc.
Operating Instructions
This section covers general operating procedures. Expe-
rience, machine familiarity, and the following information
will lead to efficient operation and good working habits.
Always operate farm machinery with safety in mind.
Pre-Start Checklist
Perform the following steps before transporting the YP30
planter to the field.
High Pressure Fluid Hazard:
Escaping fluid under pressure can have sufficient pressure to
penetrate the skin. Check all hydraulic lines and fittings before
applying pressure. Fluid escaping from a very small hole can
be almost invisible. Use paper or cardboard, not body parts,
and wear heavy gloves to check for suspected leaks. If an acci-
dent occurs, seek immediate medical assistance from a physi-
cian familiar with this type of injury.
❑ Carefully read “Important Safety Information” on
page 1.
❑ Install seed rate meters appropriate for crop. To
change meters, see “Seed Meter Setup and
Adjustment” on page 74.
❑ Install seed wheels appropriate for crop. To change
wheels, see “10HD, 25P Meter Wheel Replace-
ment” on page 76 or “20P Meter Wheel Replace-
ment” on page 80. With finger meters, make sure
correct 6- or 12-finger units are installed for the
intended row spacing.
❑ Lubricate planter as indicated under “Lubrication
and Scheduled Maintenance” on page 107.
❑ Check all tires for proper inflation. See “Tire Infla-
tion Chart” on page 137.
❑ Check all bolts, pins, and fasteners. Torque as
shown in “Tire Inflation Chart” on page 137.
❑ Check planter for worn or damaged parts. Repair or
replace parts before going to the field.
❑ Check hydraulic hoses, fittings, and cylinders for
leaks. Repair or replace before going to the field.