Monarch Instrument DC 2000 - Manual (Page 94)

Page 5-28
Chapter 5 Programming
5.6.12.2 Hi Peak
Calculated Point Types with a Point Range of Hi Peak keep track of the highest data of a given point. This
data is stored until some form of reset occurs. When the data is reset, the Hi Peak Point data is printed
on the Alarm log along with the current time and the time the peak value occurred if Reset print is enabled.
The Point Setup menu for Hi Peak will be displayed and may require programming the following parameters:
Point Tag Section 5.6.5.1
Decimal fix Section 5.6.5.4
Basepoint Section 5.6.5.12
Engineering Units Section 5.6.5.9
Reset Control Section 5.6.5.13
Alarm Setpoint Section 5.6.5.10
Chart Scale Section 5.6.5.11
NOTE: When Calculated Point Types of Hi Peak, Lo Peak, or time Average point ranges are reset, the
new value will be the current base point value at the time of reset.
5.6.12.3 Lo Peak
Calculated Point Types with a Point Range of Lo Peak keep track of the lowest data of a given point. This
data is stored until some form of reset occurs. When the data is reset, the Low Peak Point data is printed
on the chart along with the current time and the time the peak value occurred if reset print is enabled. The
Point Setup menu for Lo Peak will be displayed and may require programming the following parameters:
Point Tag Section 5.6.5.1
Decimal fix Section 5.6.5.4
Basepoint Section 5.6.5.12
Engineering Units Section 5.6.5.9
Reset Control Section 5.6.5.13
Alarm Setpoint Section 5.6.5.10
Chart Scale Section 5.6.5.11
5.6.12.4 HiLo Difference
This Calculated point type takes the difference between the lowest and highest values in a group of points.
A First Point number is assigned and a Last Point number is assigned. The difference is taken from those
points inclusive. This point must be outside of the group of points. The Point Setup menu for HiLo
Difference will be displayed and may require programming the following parameters:
Point Tag Section 5.6.5.1
Decimal fix Section 5.6.5.4
Basepoints Section 5.6.5.12 (Pick starting and ending Basepoints)
Engineering Units Section 5.6.5.9
Alarm Setpoint Section 5.6.5.10
Chart Scale Section 5.6.5.11