Monarch Instrument DC 2000 - Manual (Page 68)

Page 5-2
Chapter 5 Programming
5.2.1 Invoking Program Menu
Press the MENU button to the far right of the button bar at the bottom of the screen. This will bring up the
Command Button bar shown in figure 5-1 below. Press the PROG (for PROGram) button to select the Program
Menu and the Program Menu button bar.
Figure 5-1 The Command Button Bar
5.2.2 Passcode Protection
It is possible to protect the programming menu with a Pass code to prevent unauthorized tampering with the
unit setup. Once a Pass code is set, any attempt to enter the programming menu by pressing the PROG
button, will bring up the Pass code menu. Use the numeric keypad to enter the Pass code and gain access to
the programming menu. To set a Pass code or change a Pass code refer to Section 5.11.2.
CAUTION: KEEP YOUR PASS CODE SAFE. IF YOU LOSE IT, THERE IS NO WAY TO CLEAR OR
RESET IT.
5.2.3 Program Menu Selections
Once the PROG button is pressed, the Program Menu shown in Figure 5-2 is
displayed. One of the entries will be highlighted. This is the program item that
will be activated when you press ENTER and is the last menu item used. Use
the UP (
↑) or DOWN (↓) Arrow Key on the Button Bar to scroll through the menu
items available in the Program Menu then press ENTER to proceed or EXIT to
return to the Command Button Bar. The system allows you to establish parameters
within the following menu items:
Time & Date Displays
Chart/ Pens Points
Record Setup Measurement
Digital I/O Com Ports
System
Figure 5-2 The Programming Menu
Time & Date
Displays
Chart/Pens
Points
Measurement
Digital I/O
Com Ports
System
Record Setup
DISPL