E-flite DHC-2 Beaver 25e ARF - Manual (Page 9)

9 E-flite DHC-2 Beaver ARF Assembly Manual
Landing Gear Installation
Required Parts
Fuselage Landing gear (right and left)
6-32 x 3/8-inch socket head screw (4)
#6 washer (4)
Required Tools and Adhesives
Ball driver: 7/64-inch Threadlock
Note: If you will be installing floats on your DHC-2
Beaver, you can skip to the next section to install
the motor and battery.
 1. Check the fit of the landing gear in the fuselage. Note
that there is a right and left landing gear assembly.
 2. Secure the left half of the landing gear using two
6-32 x 3/8-inch socket head screws and two
#6 washers. Use a 7/64-inch ball driver to tighten
the screws.
Note: Make sure to use threadlock on all screws so they
do not vibrate loose.