E-flite DHC-2 Beaver 25e ARF - Manual (Page 33)

33 E-flite DHC-2 Beaver ARF Assembly Manual
Radio Installation
Required Parts
Fuselage assembly Servo w/hardware (2)
Brass pushrod connector Connector backplate
Clevis (3) Clevis retainer (3)
Pushrod connector (2) 3mm setscrew
Hook and loop material Receiver
23 7 / 8
-inch (606mm) pushrod wire
24 7 /
8
-inch (631mm) pushrod wire
25 7 / 8
-inch (658mm) pushrod wire
Required Tools and Adhesives
Pin drill Thin CA
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)
Phillips screwdriver: #1 Side cutters
 1. Install the grommets and brass eyelets for the rudder
servo. Use a pin drill and 5/64-inch (2mm) drill bit to
enlarge the outer holes (right and left) of the servo arm.
 2. Remove the two arms (front and rear) from the servo
horn using side cutters.
 3. Slide the brass pushrod connector into the outer hole
of the servo arm as shown.