E-flite DHC-2 Beaver 25e ARF - Manual (Page 27)

27 E-flite DHC-2 Beaver ARF Assembly Manual
Rudder and Elevator Installation
Required Parts
Fuselage Rudder/fin assembly
Stabilizer/elevator assembly Rudder control horn
Tail wheel assembly Tail wheel control horn
Nylon wing bolt (2) Wing strut (2)
Wing assembly
#2 x 3/8-inch sheet metal screw (4)
Required Tools and Adhesives
Phillips screwdriver: #1 Flat blade screwdriver
Ruler Felt-tipped pen
Thin CA Hobby knife w/new #11 blade
Square Threadlock
Sandpaper
Hex wrench (included with kit)
 1. Use a #1 Phillips screwdriver to remove the four
screws holding the tail cone in position. Set the screws
aside in a safe location at this time.
 2. Attach the wing to the fuselage using a flat blade
screwdriver and the two nylon wing bolts.
 3. Attach the wing struts to the wing and fuselage using
two #2 x 3/8-inch sheet metal screws for each wing strut.
Use a #1 Phillips screwdriver to tighten the screws. Holes
have been pre-drilled for the wing strut screws in both the
fuselage and the bottom of the wing.