E-flite DHC-2 Beaver 25e ARF - Manual (Page 28)

28 E-flite DHC-2 Beaver ARF Assembly Manual
 4. Slide the stabilizer into position. Center the stabilizer
as shown in the photo.
A A A=A
 5. Using a ruler, measure from each stabilizer tip to the
corresponding wing tip. The measurements must
be equal. If not, reposition the stabilizer until both
measurements are equal.
A A
A=A
 6. Check the alignment between the wing and stabilizer.
They should be parallel to each other. If not, lightly sand
the stabilizer saddle until the wing and stabilizer are in
alignment with each other.
Parallel
 7. Once the tail of your Beaver has been aligned,
use a felt-tipped pen to trace the outline of the fuselage
on the stabilizer.