E-flite DHC-2 Beaver 25e ARF User Manual

Page 32

E-flite DHC-2 Beaver ARF Assembly Manual



14. Slide the fin up slightly so the rudder control horn

can be installed on the rudder control rod. Use a setscrew

and the provided hex wrench to tighten the setscrew on

the flat area of the control rod. Note that the tab on the

horn faces toward the top of the fuselage when installed.

Note: It is very important to use threadlock to ensure this

assembly does not come apart during flight.

Note: Do not mix up the rudder and tail wheel

control horns. They are packaged separately as they

are not interchangeable.



15. Wick thin CA into the joint between the fuselage

and fin. Make sure the fin is glued into the slot in the

fuselage, as well as to the top of the fuselage.

Note: If you are installing floats please continue to the

next section of the manual.



16. Install the tail wheel and control horn at this

time. Use threadlock on all set screws to ensure

trouble-free operation.