E-flite DHC-2 Beaver 25e ARF - Manual (Page 46)

46 E-flite DHC-2 Beaver ARF Assembly Manual
 10. Secure the rear cockpit floor in the fuselage using
four #2 x 3/8-inch sheet metal screws. The screws will go
through the rear cockpit floor and into the block installed
in Step 8. Route the leads for the flaps and ailerons from
underneath the floor at this time.
 11. Trim the center and rear side windows from the
window set using hobby scissors and a hobby knife.
 12. Use canopy glue to secure the remaining side
windows to the inside of the fuselage.