E-flite DHC-2 Beaver 25e ARF - Manual (Page 12)

12 E-flite DHC-2 Beaver ARF Assembly Manual
 3. Use hook and loop tape to mount the speed control to
the front of the battery box as shown. You will need to
attach a 9-inch extension onto the ESC plug to route it to
the receiver.
 4. Plug the leads together between the motor and speed
control. Secure the wires so they will not interfere with the
operation of the motor.
 5. Use a hobby knife and rotary tool to remove the area
in the center of the dummy radial engine. Use a hobby
knife to remove the area between each of the cylinders to
allow cooling air to pass through the cowling and over
the motor. Use 6-minute epoxy to glue the dummy radial
engine inside the cowling. Use the following colors to
paint the dummy radial engine.
Note: We used the following colors when painting
the engine:
Rocker Shafts – Aluminum
Engine Cylinders – Black
Plug Wires – Yellow
Center Crankcase – Lt. Gray