E-flite DHC-2 Beaver 25e ARF User Manual

Page 25

E-flite DHC-2 Beaver ARF Assembly Manual

Note: The following steps will be performed while

you have epoxy mixed. Make sure the steps can

be performed before the epoxy begins to cure. It is

suggested to make a test run of the steps if you are

unsure of the procedure.



4. Mix up some 30-minute epoxy and apply it to one half

of the joiner. Make sure to coat the top, bottom and both

sides of the joiner.



5. Coat the root rib of the wing panel with epoxy. Apply

epoxy into the opening for the joiner as well.



6. Slide the joiner into the wing panel. Apply epoxy to

the joiner and to the wing as described in Step 5 and

slide the two wing panels together.