E-flite DHC-2 Beaver 25e ARF - Manual (Page 43)

43 E-flite DHC-2 Beaver ARF Assembly Manual
Windows, Cockpit and
Air Scoop Installation
Required Parts
Fuselage assembly Cockpit kit (optional)
Side window set Front windscreen
Air scoop (2)
Required Tools and Adhesives
Canopy glue Hobby scissors
Hobby knife Low-tack tape
Optional tools:
Drill Drill bit: 5/64-inch (2mm)
Phillips screwdriver: #1 Medium CA
Note: If you are not installing the optional cockpit,
perform Steps 4, 5, 7, 11 and 12.
 1. Use medium CA to secure the instrument panel in
position as shown.
 2. Test fit the forward cockpit floor in the fuselage. Trim
the floor as necessary using hobby scissors. The cockpit
floor is then glued in using medium CA.