E-flite DHC-2 Beaver 25e ARF User Manual

Page 34

E-flite DHC-2 Beaver ARF Assembly Manual



4. Secure the connector using the connector backplate.

Note: If you are installing floats, prepare the rudder

control horn as shown. The pushrod and brass connector

will be on the same side of the servo horn.



5. Repeat Steps 1 and 2 to prepare the elevator servo.



6. Place the elevator servo into the fuselage with

the output facing to the front. Use a pin drill and

1/16-inch (1.5mm) drill bit to drill the holes for the

servo mounting screws.