E-flite DHC-2 Beaver 25e ARF - Manual (Page 20)

20 E-flite DHC-2 Beaver ARF Assembly Manual
 12. Slide a clevis retainer onto a nylon clevis. With the
aileron servo centered using the radio, thread the clevis
onto the pushrod. Connect the clevis to the aileron control
horn. Adjust the length of the pushrod by threading the
clevis in or out until the aileron is centered.
 13. Repeat Steps 1 through 12 for the remaining
aileron servo.
 14. Prepare the flap servos for installation by removing
any unnecessary arms from the servo horns as shown.
You will also need to clean up the cuts to prevent any
portion of the removed arm from rubbing against the
servo cover when the servos are installed. Install any
grommets and brass eyelets at this time as well. The
servos will have the arms installed to match each other
as shown in the photo.
Note: The arms are shown in the center position
(which will be the mid flap position) if you are using
three-position flaps. Make sure when using proportional
flaps that the control has been centered before installing
the servo horns.