E-flite DHC-2 Beaver 25e ARF User Manual

Page 23

E-flite DHC-2 Beaver ARF Assembly Manual

Note: Do not place or secure the flap servo cover in

position before turning on the radio and checking the

operation of the flap. Doing so could damage the flap

control horn or quite possibly the flap servo. Check the

length of the linkage as follows BEFORE installing the

flap servo cover.



20. With the radio system on, move the control on the

radio to the "Up Flap" position and test fit the cover. If

the cover does not fit without binding the flap or flap

servo, adjust the length of the linkage or change the

end points at the radio system to eliminate any binding.

Repeat the process for "Down Flap" and check that the

full throw is adjusted as noted in the "Control Throw"

section of this manual.



21. Secure the flap servo cover to the wing using

four #2 x 3/8-inch sheet metal screws and a

#1 Phillips screwdriver.



22. Repeat Steps 15 through 21 to install the remaining

flap servo.