E-flite DHC-2 Beaver 25e ARF - Manual (Page 47)

47 E-flite DHC-2 Beaver ARF Assembly Manual
 13. Use medium CA to glue the air scoops to the fuselage
using the images below and those on the box as guides.
Control Throws
 1. Turn on the transmitter and receiver of your DHC-2 Beaver.
Check the movement of the rudder using the transmitter.
When the stick is moved right, the rudder should also move
right. Reverse the direction of the servo at the transmitter if
necessary.
 2. Check the movement of the elevator with the radio system.
Moving the elevator stick down will make the airplane
elevator move up.
 3. Check the movement of the ailerons with the radio system.
Moving the aileron stick right will make the right aileron
move up and the left aileron move down.
 4. Use a ruler to adjust the throw of the elevator, ailerons
and rudder. Adjust the position of the pushrod at the control
horn to achieve the following measurements when moving the
sticks to their endpoints.
Note: Measurements are taken at the widest point on
the surface.