E-flite DHC-2 Beaver 25e ARF - Manual (Page 38)

38 E-flite DHC-2 Beaver ARF Assembly Manual
 17. After centering the tail wheel, tighten the 3mm
setscrew to secure the pushrod. Use this connection to
trim the steering of your Beaver on the ground. DO NOT
use the radio trim to correct the steering trim.
Note: Your kit will use a 3mm setscrew instead of the
machine screw shown in the photo.
 18. Install the tail cone using the screws that
were removed earlier in the manual and a
#1 Phillips screwdriver.