E-flite DHC-2 Beaver 25e ARF - Manual (Page 16)

16 E-flite DHC-2 Beaver ARF Assembly Manual
Aileron and Flap Servo Installation
Required Parts
Wing panel (right and left) Aileron servo cover (right and left)
Servo mounting blocks (8) Nylon clevis (4)
Clevis retainer (4) Pushrod connector (4)
Flap servo cover (2) 2 1 /
2
-inch (58mm) pushrod (2)
2 3 / 16
-inch (56mm) pushrod (2)
Servo extension, 3-inch (76mm) (2)
Servo extension, 12-inch (305mm) (2)
#2 x 3/8-inch sheet metal screw (16)
Required Tools and Adhesives
Thin CA Pin drill
Drill Side cutters
Phillips screwdriver: #1 Pencil
String Ruler
Low-tack tape 6-minute epoxy
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)
 1. Position the aileron servo on the servo cover so
the arm is centered lengthwise in the cutout. The arm
will align with the edge of the servo cover as well. Use a
pencil to mark the position of the servo on the cover.
 2. Use 6-minute epoxy to glue the servo mounting
block to the servo cover as shown. Allow the epoxy to
fully cure before proceeding.