E-flite DHC-2 Beaver 25e ARF User Manual

Page 14

E-flite DHC-2 Beaver ARF Assembly Manual



9. Secure the spinner cone to the backplate with the

screws provided with the spinner. Use a #1 Phillips

screwdriver to tighten the two screws.



10. Carefully remove the hatch from the bottom of the

fuselage. It is held at the rear with two magnets. To open

the hatch, insert your thumb and index finger into the

cups and pinch towards the middle of the hatch. Then lift

towards one side to release one magnet and then pull up

and away from the model to release the second model.

Note: If you are not flying with floats you may wish to

cut the plastic cups out of the hatch and make two holes

for your fingers.

If you intend to fly on floats, then you may wish to leave

the cups in place.