E-flite DHC-2 Beaver 25e ARF - Manual (Page 39)

39 E-flite DHC-2 Beaver ARF Assembly Manual
 19. Use hook and loop tape to secure the receiver inside
the fuselage. If you are using a remote receiver, secure it
as far away and as far up in the fuselage as possible.
Optional Float Installation
Required Parts
Fuselage assembly Float set w/hardware
Beaver float mount (included with kit)
Landing gear plug (2)
Required Tools and Adhesives
Drill Thin CA
String Threadlock
Phillips screwdriver: #2 Silicone adhesive
Hex wrench (included with kit)
Drill bit: 5/64-inch (2mm), 1/8-inch (3mm)
Note: The hardware used to mount the floats and struts
to your Beaver is from the E-flite float set (EFLA500).
 1. Install the float mount braces between the front and
rear float supports as shown in the image below.