E-flite DHC-2 Beaver 25e ARF - Manual (Page 36)

36 E-flite DHC-2 Beaver ARF Assembly Manual
 11. Slide a clevis retainer onto a nylon clevis. Thread the
clevis about 14 turns on the rudder pushrod. The exact
position will be adjusted later in the manual.
 12. Connect the clevis to the rudder control horn. Slide
the clevis retainer over the clevis to prevent the clevis
from opening and becoming disconnected from the
rudder control horn.
 13. Slide the pushrod into the hole in the servo horn and
secure it using a pushrod connector.
 14. Plug the rudder servo into the radio system and
check the operation of the rudder servo. Center both
the rudder stick and trim. Adjust the clevis to center
the rudder while the radio is still on. Once centered,
turn off the radio.