Metrohm IC Net 2.2 User Manual
Page 96
6 Devices
IC Net 2.2
88
automatically switched off. At the same
time, the
Pressure
field color in the 709 set-
tings window and in the
WATCH WINDOW
is
changed to the value set for
Out of range
.
Send current parameters immediately to the
709 IC Pump (only available if pump is run-
ning). Parameters are not stored in the sys-
tem file (
*.smt
) as long as the file is not
saved.
Set current parameters and start 709 IC
Pump drive.
Stop 709 IC Pump drive.
Links
The
Links
tab of the
709 IC Pump
is used for COM port selection
and settings (details see section 5.2.4 Links).
Advanced
The
Advanced
tab of the
709 IC Pump
window is only available for a
connected system.
Correction factor
Flow correction factor to adjust the dis-
played flow to the actual flow measured
with the aid of a measuring cylinder.
Entry range:
0.90 ... 1.10
Read
current
Correction factor
value.
Send
current
Correction factor
value to the
709 IC Pump. This parameter is not stored
in the system file (
*.smt
) as long as the file is
not saved.